What does a servo motor wiring harness wiring diagram look like?

Servo motor wiring harness wiring main circuit is divided into two categories of DC and AC servo motors, including R, S, T three-phase wires and U, V, W and motor wiring, PLC connects to the drive's CN1, and the encoder is connected to CN2. Nowadays, servo motor wiring harnesses are mostly AC servo. So its power cable is not much different from ordinary three-phase asynchronous motors. Power line from the Yaskawa servo motor harness drive power module to the motor power port encoder, from the servo encoder port to the motor encoder port, according to the encoder signals, some may have to add an intermediate conversion device.1. servo motor harness, that is, the drive to the motor for three-phase AC power supply, generally three or four wires; 2. encoder signal line, the position signal is fed back by the encoder to the drive calculation. Nowadays, servo mostly use AC servo, so its power line and ordinary three-phase asynchronous motor is not much different. Power cord from the servo drive power module to the motor power port: divided into two categories of DC and AC servo motors, its main feature is that when the signal voltage is zero no spin phenomenon, speed with the increase in torque and a uniform decline. AC Mitsubishi servo motor harness motor stator construction is basically similar to the capacitor split-phase single-phase asynchronous motor. The stator is equipped with two position difference of 90 ° winding, one is the excitation winding Rf, it is always connected to the AC voltage Uf; the other is the control winding L, connected to the control signal voltage Uc. So AC servo motor is also known as two servo motor. AC servo motor rotor is usually made into a squirrel cage, but in order to make the servo motor has a wide speed range, linear mechanical characteristics, no "spin" phenomenon and fast response performance, it is compared with ordinary motors, should have a large rotor resistance and small moment of inertia of the two characteristics. There are many reasons why the motor is not controlled, such as bad line contact, and the original failure of the motor, and the original failure of the controller, the grounding problem is also possible, because the surrounding interference signal is too large to cause the signal error.-3、About Evergrande Electronic Products Network platform related to the introduction and sales of products briefly: Evergrande Electronic Products Network - a professional agent / production / sales of a variety of {connectors | wiring harness | wire and cable products }; if you have a related [connectors | wiring harness | wire and cable products] purchasing / sourcing needs or would like to buy / to understand what connectors | harness | wire and cable products we can provide solutions, please contact the following Division I business personnel; If you have related [connectors | wire harness | wire and cable products] sales / resources and promotion needs, please click on the "¡¡ Business Cooperation ←" with the person to discuss!