Things to keep in mind when designing medical connector cables

First, on the design of the same as the original connector or cable. There are a lot of maintenance or agent of the original medical equipment customers with the original product to do the design. 1. If there are appearance patents or structure patents, you need to pay attention. There are also some customers require the size of the design out with the original exactly the same, you know, is the same manufacturer of the same batch of products will have tolerances, not to mention take the original product copy number. 2. cost issues. Many of the original products are used in the better materials, some of which are not available domestically, can only be imported. The cost will be very high, the customer will not accept. Special attention should be paid to some materials may be involved in some political factors, there is always the possibility of being out of stock. The project must be clear with the customer before construction, there is a domestic alternative must be prioritized to choose domestic. 3. structure. There are a lot of products with complex structural design, if the design is the same, that has not considered the production and processing issues? Designed accessories, must be convenient for production and processing. If not good production and processing, then make out the product defective rate will be very high, and production efficiency will be very low, directly resulting in higher costs. Second, the customer has developed a host of equipment, the need for supporting connectors and connecting wires. 1. This design case is relatively simple, first consider the use of customer equipment environment, waterproofing, salt spray resistance, etc.. Determine the use of the environment, it is good to choose the structure of the connector and the material of the connecting line. 2. Determine the use of the equipment. Need to be frequently used, if often used, it is recommended that the design into a push-pull self-locking structure. If not often used, can be similar to the M8 connector and other threaded locking method. 3. Determine the size of the customer can use the connector connection line. This will determine the connector interface type. Third, the customer's products in the design and development stage or only program. This design case is the most complex, need to consider many factors. Design time must pay attention to consider the customer's host device, can not only consider the connector and connection line. Because once there is a need to modify a certain place, then the entire connector and connection line may need to be pushed back to redesign, here need special attention.-2、About Evergrande Electronic Products Network platform related to the introduction and sales of products briefly: Evergrande Electronic Products Network - a professional agent / production / sales of a variety of {connectors | wiring harness | wire and cable products}; if you have a related [connectors | wiring harness | wire and cable products] purchasing / sourcing needs or would like to buy / to understand what connectors | harness | wire and cable products we can provide solutions, please contact the following Division I business personnel; If you have related [connector | wire harness | wire and cable production] sales / resources and promotion needs, please click on the ¡¡ Business Cooperation ← ¡" to discuss with a person!