What should I know about marine cable utilization?

Marine cable is a kind of wire and cable used for power, lighting, control and communication transmission of all kinds of ships in river, sea and offshore or offshore buildings, including marine power cable, marine control cable, marine communication cable and so on. Twisting, will bring a lot of trouble. If the cable is not distorted, i.e. it is not possible to connect the cable to one end of the cable coil or cable tray, the correct method is to rotate the cable tray in order to open the cable slowly. This is the only way to ensure that the cable works properly. The second thing to keep in mind is to make sure that the cables are decentralized on the operating side of the device, i.e. the cables must not be bundled together and electrically charged in contact with each other. This phenomenon, which has been proven in practice, usually appears easily as a fault and therefore attracts attention. The next thing to look out for is to make sure that the cables move completely within the zigzag radius when using the equipment. This means that it is not possible to move the cable forcibly. If the cable is moved forcibly, serious damage will result. It is also important to check the cable orientation to ensure it is correct after the unit has been in operation for a while. It is the operating end of the drag chain that breaks and should be replaced promptly. Marine cable is very soft wire, so we can not make it deformed, as long as the deformation, it is easy to break. Of course, the installation of the equipment is more important. Usually, there are drag chain cables as fixtures. Manufacturers of marine cables believe that the cable will break immediately after deformation. Therefore, when placing a mobile cable, we must pay attention to the following facts: when placing it, it must be very loose. If it is too stiff, the cable will break and therefore care must be taken. Please be careful when placing the cable. In the case of poor operating conditions on site, the requirements for safety cannot be reduced one bit. The division of labor must be clear and safety precautions should be specific. High-voltage fences should be located close to external signage and watched by a person. Especially at the other end of the cable, it is necessary to assign someone to protect the cable and to adhere to communications to prevent emergencies. Test equipment and wiring should meet safety requirements and operation should be standardized. During the test, please pay attention to the stress convergence and the operator should stand on the insulating mat. When changing the wiring or at the end of the test, the test power should be disconnected and the high voltage part of the high voltage equipment should be short-circuited to earth. During HV DC testing, the cable should be discharged to ground several times before touching it at the end of the test or at the end of the test.-2、About Evergrande Electronic Products Network platform related to the introduction and sales of products briefly: Evergrande Electronic Products Network - a professional agent / production / sales of a variety of {connectors | wiring harness | wire and cable products }; if you have a related [connectors | wiring harness | wire and cable products] purchasing / sourcing needs or would like to buy / to understand what connectors | harness | wire and cable products we can provide solutions, please contact the following Division I business personnel; If you have related [connectors | wire harness | wire and cable products] sales / resources and promotion needs, please click on the "¡¡ Business Cooperation ←" with the person to discuss!