We need to pay special attention to the problems when testing terminal harnesses

　We need to pay special attention to the problem when detecting the terminal harness: 1. The specification of the cut line can not be out of tolerance, the knot should be flat and aligned. 2. Observe the surface of the extruded wire body is not the occurrence of scratches, grains, miscellaneous, dirty and other defects. 3. Extruded wire should be adjusted to the two-core line, can not occur off-core bad line. 4. The surface of the wire should be neat and clean, and can not occur dirty, scratches, the inner core of the wire outside the scratches or damage and so on. 5. Wire file if injection molding, to observe whether the occurrence of shrinkage, phi, lack of glue, deformation and other bad. 6. Hit the terminal can not occur deep hit, shallow hit, interrupt the copper wire, hit the bad and so on bad. 7. Clear terminal harness before wearing rubber shell to wear the heat-shrinkable tube.

8. Terminal harness penetration into the rubber shell wire tone line order is not produced by wear reverse, not wear in place and other bad.

2, on the 3M electronic products network platform related to the introduction and sales of products brief: 3M electronic products network - professional agent / production / sales of a variety of {connectors | wiring harness | wire and cable products }; if you have a related [connectors | wiring harness | wire and cable products] purchasing / sourcing needs or would like to buy / to understand which connectors | wiring harness | wire and cable products we can provide solutions, please contact the Division I business personnel below; If you have related [connectors | harness | wire and cable products] sales / resources and promotion needs, please click on the ¡¡ Business Cooperation ← ¡" to discuss with a person!