Medical Device Harness Processing Requirements?

Medical Equipment Wiring Harness Processing Requirements? 1. After the terminal is pressed, the rubber shell needs to be worn. This process cannot be produced automatically, it can only be produced manually. Also need to compare the first thing. Production line workers should be trained to ensure that the rubber shell is worn correctly, worn in place and does not fall off. . 2. After the wiring harness is completely completed, it needs to be comprehensively inspected by the quality department. Unqualified products are reworked from scratch. 3. The incoming materials should be correct, the raw materials should be checked, and the waste should be eradicated from the source. 4. If it is other complicated wiring harnesses, it may be necessary to wear sleeves, heat shrink, etc. . 5. After confirming the materials, it is necessary to cut the wires and punch the terminals, and the first piece needs to be done well. The subsequent production and inspection should be based on the first piece.

-------------------------------------------------------------------------------------------------

How to maintain the wiring harness of medical equipment? 1. Fine daily maintenance is very important to ensure the normal operation of instruments and equipment. Usual maintenance seems simple, but in many cases, it is not highly valued by others and easily overlooked; But in many cases, big problems are usually accumulated by small problems. Make sure to work closely with clinical medical application personnel, keep the surface of the instrument clean, make sure to check whether the working voltage and switching power supply are normal, pay attention to whether the instrument is normal, and fill in the application records. Cultivate good habits in daily maintenance to prevent the destruction of vicious events. 2. In equipment maintenance, it must be solved carefully and don't be careless. When common failures occur in instruments and equipment, information should be collected and prepared before maintenance; Including model specifications, original serial numbers, common failure times, abnormal noise, sudden power outages, instrument movements and other issues. 3. Pay attention during maintenance. In the whole process of disassembling and assembling medical devices, pay attention to the sequence, and don't use strange force to forcibly remove the buckle. The removed tightening screws and large pieces can't be stacked at will, but should be placed in categories to prevent loss. After the equipment maintenance is completed, during installation, it should be gradually restored to its original state in reverse order, without unnecessary parts. Damaged parts should also be marked and restored to their original state after disassembly, without erroneous leakage. 4. After the maintenance is completed, clean the surface of the instrument and connect the switching power supply to see if everything is normal. . Calibrate the instrument to restore operating state, and then hand it over to the application personnel to check whether the instrument has restored normal operating state to prevent safety risks. Finally, clear the site, check whether special tools have been ignored, and fill in the maintenance system log, leaving an inspection book. The above is about the detailed introduction of "Medical equipment wiring harness processing requirements, medical equipment wiring harness maintenance methods?" I hope it can help everyone.

---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- If you have related [connector wiring harness and cable production] purchasing/purchasing needs or want to purchase/understand which connector wiring harness and cable product solutions we can provide, please contact our business staff below; If you have related sales/resources and promotion needs of [Connector Wiring Harness and Cable Production], please click "→ Business Cooperation ←" to negotiate with a dedicated person!