Medical equipment wiring harness processing requirements, how to solve the medical equipment wiring harness processing broken wire?

What are the requirements for medical equipment wiring harness processing? The wire harnesses we usually see are all products, but in the process of wire harness processing and production, the requirements for wire harnesses are very severe. So how severe are they? Next, Huichengyuan Xiaobian will take you to understand.

Medical Equipment Wiring Harness Processing Requirements? 1. After the terminal is pressed, the rubber shell needs to be worn. This process cannot be produced automatically, it can only be produced manually. Also need to compare the first thing. Production line workers should be trained to ensure that the rubber shell is worn correctly, worn in place and does not fall off. . 2. After the wiring harness is completely completed, it needs to be comprehensively inspected by the quality department. Unqualified products are reworked from scratch. 3. The incoming materials should be correct, the raw materials should be checked, and the waste should be eradicated from the source. 4. If it is other complicated wiring harnesses, it may be necessary to wear sleeves, heat shrink, etc. . 5. After confirming the materials, it is necessary to cut the wires and punch the terminals, and the first piece needs to be done well. The subsequent production and inspection should be based on the first piece.

-------------------------------------------------------------------------------------------------

How to solve the broken wiring of medical equipment wiring harness processing? 1. For excessive counter-pulling force, the solution is to adjust the number of turns of winding on the drum. 2. Wire has impurities, the solution is to strengthen the acceptance of raw materials. 3. Aluminum rod is wet, the solution is not to use wet aluminum rod temporarily. 4. Poor lubrication, the solution is to check the lubrication system, measure the composition and temperature of lubricant, 5. The solution is to adjust the number of turns of winding on the drum to correct the worn drum. 6. The die configuration is unreasonable, the solution is to adjust the die to eliminate the deformation process large and too small. 7. The joint is not firm, the solution is to adjust the current, electrification time and pressure of the welding machine. The solution was to repair the mold strictly to the standards. The diameter area must not be too long to ensure the cleanliness of the mold The above is about the detailed introduction of "Medical equipment wire harness processing requirements, how to solve the broken wire of medical equipment wire harness processing?" If you have other questions, you can contact us at any time.

---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- If you have related [connector wiring harness and cable production] purchasing/purchasing needs or want to purchase/understand which connector wiring harness and cable product solutions we can provide, please contact our business staff below; If you have related sales/resources and promotion needs of [Connector Wiring Harness and Cable Production], please click "→ Business Cooperation ←" to negotiate with a dedicated person!