Categorization：Harness Component
I-PEX | CABLINE ® -CX II/20974-040T-01 very thin coaxial harness is produced by I-PEX company: 0.25 mm pitch, horizontal plug mode, Very thin coaxial wire connector with EMC shield and mechanical lock, very thin coaxial wire connector of CABLINE ® -CX II/20974 -040T-01 combined with very thin coaxial wire (AWG): # 44 # 46.
1、 Japan I-PEX | CABLINE ® -CX II/20974 -040T-01 Specifications, features and pictures of connectors used for ultra-thin coaxial harness: 0.25 mm pitch, horizontal butt joint, Very thin coaxial connector with EMC shield and mechanical lock Ideal for small electronics with limited space 360 ˚ EMC shield Mechanical lock shield Protects against EMI EMC shield and multi-point grounding Design Contact spacing (mm): 0.250Height: 1.00 Max Available Pin count: 40 AWG: # 44 # 46 Mating Type: Horizontal
2、 Japan I-PEX | CABLINE ® -CX II/20974-040T-01 List of Part/Model of Connector Used for Very Thin Coaxial Harness:
| Part Number Description | Pin count | Part Number | |
| PLUG FOR CABLE ASSEMBLY | 40 | 20977-040T-01 | |
| Plug parts | PLUG HOUSING | 40 | 20974-040T-01 |
| PLUG SHELL | 40 | 3655-0401 | |
| PLUG LOCK BAR ASSEMBLY | 40 | 20975-040T-01 | |
| RECEPTACLE | 40 | 20976-040E-01 | |
3、 Japan I-PEX | CABLINE ® -CX II/20974-040T-01 The structure/diameter of the very thin coaxial wire used in the very thin coaxial wire harness is shown in the figure:
4、 Japan I-PEX | CABLINE ® -CX II/20974 -040T-01 Production Process of Very Thin Coaxial Wire Harness Brief Description: The main process of wire harness preparation:
4.1: Prepare the cable assembly 4.2: Install the cable assembly to the male body assembly and solder the exposed wire to the male signal terminal 4.3: Position the latch assembly (or latch) Male part 4.4: Cover the male housing and solder the required area to complete the male harness First, prepare the very thin coaxial line to facilitate the harness assembly. Pretreated cables are referred to as cable assemblies. This pretreatment simplifies the cable welding process of the connector and improves the stability of the quality of the male harness. This is done before the cable is soldered to the connector.
Condly, the outer conductor of the cable is welded on the connector shell, and the outer conductor of the cable is electrically connected with the PCB through the connector to obtain good grounding characteristics.
5、 Japan I-PEX | CABLINE ® -CX II/20974 -040T-01 Very Thin Coaxial Harness Product Picture (Picture is for reference only)
6、 Japan I-PEX | CABLINE ® -CX II/20974 -040T-01 Very Thin Coaxial Harness This product is manufactured/sold by:
“Without the consent or authorization of this site, no one shall reproduce, reprint, distribute, cite, change, broadcast or publish the content in whole or in part in any form, nor shall there be any other violation of the copyright of this site.
