2024-09-05
Often when connecting two optical fibers, due to the location, structure and shape of the two fibers are different, so that the optical fiber can not completely transmit the signal to the other fiber,...
2024-09-05
Harness processing engineering team in the customer drawing design, mainly contains: product size chart, product BOM details and dosage, product mechanical properties of raw materials and physical pro...
2024-09-05
On a PCB where multiple connectors need to be mated to interconnect at the same time, this can be relatively complex because the possibility of misalignment is higher when multiple connectors are used...
2024-09-05
There is also a big difference between the manufacturers of the entire electronic wiring harnesses because there are a lot of their own manufacturers when it comes to the production of the products. D...
2024-09-05
Why use mixed flow gas to test connectors? In fact, Mixed Flow Gases is a test that was developed specifically for similar corrosion tests commonly used on connectors. Mixed flow gases (MFG) are used ...
2024-09-05
First, to ensure that the choice of appropriate manufacturers: want to identify the quality of wiring harness processing products, or should first do a good job of choosing the manufacturer, after all...
2024-09-05
Terminal plating is a metal electrodeposition process, refers to simple metal ions or complex ions through electrochemical methods in the solid (conductor or semiconductor) surface discharge reduction...
2024-09-05
1, with a good tensile strength of the elongation of the characteristics of the insulating material is now insulated covered guess the toughness and wear resistance, corrosion resistance of A material...
2024-09-05
1. The main cause of the depression phenomenon: the design of a large gate first solidification can not be spread over the region and shrinkage; should be appropriate selection of materials to reduce ...
2024-09-05
Harness for a certain load source group to provide service equipment as a whole, such as trunk lines, communication devices, control systems and so on. The basic study of the theory of voice service i...
2024-09-05
RF connector, also known as China connector, power plugs and power sockets, generally refers to household appliances RF connector, that is, the linkage of two active components of the components, the ...
2024-09-05
For the development of connector manufacturers, in addition to the productivity of connector products, focus on the quality of connector products can be said to be the focus. Because the quality of th...
2024-09-05
Micromotion its movement is usually less than 0.005 inches (0.127 mm), under the right circumstances, almost all materials that will oxidize are at risk of micromotion corrosion. And electronic connec...
2024-09-05
1. Low-voltage wiring harness to enhance the level of automation to improve gross margins automotive low-voltage wiring harness models vary greatly in their own characteristics, 70% man-made resulting...
2024-09-05
As automation and the Internet of Things transform industrial environments, demand for PCB board-to-board connector products with features for signal, data and power transmission and shielding from ha...
2024-09-05
The industrial sector has transitioned from mechanical to electronic controls and is now in the middle of digital transformation. The rise of smart cities, smart grids, smart factories, and smart IoT ...
2024-09-05
Automotive wiring harness is often likened to the neural network of the car, connecting various electronic and electrical components of the car and providing stable electrical energy and signal data, ...
2024-09-05
RJ45 connectors are very common in the application of network equipment, because the interface of the RJ45 socket connector is divided into 2 types of arrangements for the connection with the equipmen...
2024-09-05
The MICRO D-SUB cable is a portable version of the USB 2.0 standard, smaller than the Mini USB connector used in some cell phones.Micro-USB is the next-generation specification of Mini-USB, which was ...
2024-09-05
1. Appearance requirements: the surface of the wiring harness after processing should be smooth, uniform skin, no air holes, cracks, indentations, bumps, breaks, spots, dirt, etc.; wiring harness and ...
