2024-09-04
What is a new energy vehicle high voltage wiring harness?
2024-09-04
Some problems and solutions in automotive wiring harness processing
2024-09-04
With the continuous improvement of modern automobile requirements for safety, comfort and environmental protection, the number of circuits and power consumption on the car increases significantly, so ...
2024-09-04
Automobile use, wiring harness failure hidden hidden strong, but the fault hazard advantage is very big, especially the wiring harness overheating and wiring harness short circuit failure, very easy t...
2024-09-04
Circuit board terminal blocks are one of the widely used products that can be soldered to printed circuit boards. Some of this series of products have solid tongue and groove splicing grooves with 02 ...
2024-09-04
Wiring Harness Manufacturing Process OverviewThe HXN5 locomotive has approximately 30 wiring harnesses, of which the harness consists of approximately 1,000 wires of various lengths and sizes, which n...
2024-09-04
Wire and cable knowledge: wire and cable to transmit electrical (magnetic) energy, information and electromagnetic energy conversion wire products. Broad wire and cable is also referred to as cable. T...
2024-09-04
Waterproof connector is a kind of connecting electronic circuit positioning connector, is composed of 2 parts, namely plug-in, and connector, in general can be completely separate, switch and waterpro...
2024-09-04
Wire harness processing manufacturers tell you on the construction of the more troublesome type of equipment, wire harness is a better wire harness, these products, although in the structure of the co...
2024-09-04
Vehicle key, high technology content, high profitability of automotive connectors are basically exclusive to foreign manufacturers, such as the engine EFI system, active transmission system, airbag sy...
2024-09-04
Automotive connectors are widely used in the power system, body system, information control system, safety system, on-board equipment, etc. The types include circular connectors, RF connectors, FCP co...
2024-09-04
The first generation of automotive connectors (Figure 1), started in 2008 or so, mainly from the industrial connectors at the time of the re-modeling. The characteristics of this generation of product...
2024-09-04
Reliability testing of automotive connectors generally touches on the following items: insertion and extraction force testing, durability testing, insulation resistance testing, voltage testing, oscil...
2024-09-04
Mechanical life of durability: to a plug and a pull out for a cycle, to the rules of plugging and unplugging cycle after the connector can be normal end of its coupling function (such as touch resista...
2024-09-04
Terminal suppliers on this test and crimp the selection of the most basic responsibility, but also has the responsibility to provide specific crimp information, so that the wire assembly supplier spec...
2024-09-04
Common mode noise is generated by illogical planning. Some typical causes are different lengths of individual wires in different pairs, or different distances to the power plane or chassis. Another ca...
2024-09-04
Good insulated terminals should first have good workmanship, visual inspection can not be passed basically do not waste time and then electrical testing. So, what kind of terminal is considered good w...
2024-09-04
Terminals pressed after the need to wear rubber shell, this step can not be automated production, only manual, but also need to compare the first piece of the production line employees should be train...
2024-09-04
Outer diameter becomes smaller, brewing resistance exceeds the standard, you should let the workers stop, test is because the monofilament diameter is small, or equipment brewing, because the first pi...
