2024-09-05
Connector wear and tear: Repeated connecting and disconnecting of connectors may cause the contact metal to wear and corrode due to exposure to irritating elements such as water, dust, dirt, etc., res...
2024-09-05
Because board-to-board connectors are soldered, it is generally not possible to observe the quality of the connector's solder joints with the naked eye. Therefore, it is necessary to use a conven...
2024-09-05
How to reduce jack and pin wear: 1, the thicker the nickel layer, the stronger the abrasion resistance of the gold-plated layer. 2, the smoother the surface, the lower the surface roughness, the lower...
2024-09-05
To the board connector in the design and production of the key place is the terminal, it is equivalent to a small connector, can be some of the same or different performance of the device connected to...
2024-09-05
With the in-depth application of MDB technology, the enterprise's design method has changed from the traditional two-dimensional drawing to the design based on three-dimensional models, and has g...
2024-09-05
In automotive applications, the wiring harness failure potential is strong, but the failure of the hazardous advantage is very large, especially the wiring harness overheating and wiring harness short...
2024-09-05
In today's world is the world of high technology, a variety of electronic devices have long been into our lives, this commodity to facilitate our daily life, change the old habits of the past, pr...
2024-09-05
Automotive wiring harness industry in the field of automotive parts belongs to the flexibility of the industry is very large, involving the change is usually very frequent, such as automobile factory ...
2024-09-05
The wiring harness manufacturing process is time-consuming, difficult and task-oriented. Nonetheless, as the demand for wire harnesses and cable assemblies grows, so does the manufacturing of these co...
2024-09-05
A wiring harness, also known as a cable harness, is a component formed by bundling multiple electrical connections (power supply, signal communication) required to connect electronic devices into a bu...
2024-09-05
Miniaturization of connectors - As connectors usually work in a variety of harsh environments and conditions, reliability must be the primary technical requirements of industrial connectors. Only reli...
2024-09-05
Power connectors are generally composed of plugs and sockets, through the plug socket and plug-in to realize the connection and cut off the circuit. In ordinary daily life and work in the application ...
2024-09-05
As the industry continues to advance, the role of electronic connectors in daily production is becoming more and more obvious; representative industrial connectors and aviation plugs are involved in m...
2024-09-05
Terminals are categorized into single terminal connections and multi-terminal connectors. For multi-bit connectors, different load densities (load density can be simply understood as the number of ter...
2024-09-05
Industrial connectors need to be easy to plug and unplug, the mating force should be low enough to meet the application requirements; but the pull-out force should not be too low to avoid easy looseni...
2024-09-05
Any electrical system uses electric current as a carrier of signals or energy from one conductor to another through contact between conductors. The contact between conductors is called electrical cont...
2024-09-05
There are a lot of board-to-board connectors in our life, mainly because it can improve efficiency and save costs; application, you need to understand the performance of the board-to-board connector, ...
2024-09-05
As connector size decreases, so does the current-carrying capacity of the connector; typically, industrial electronic connectors can handle currents between 200mA and 500mA, which is about half the cu...
2024-09-05
Plug-in connection method: Plug-in connection method is a multi-purpose connection form, the connector plug and socket connection or separation does not need to be twisted or rotated. Its action is a ...
2024-09-05
Harness processing machine repair is a skill in itself, and is still at the operational level, which is what most harness processing repairmen are currently doing. He said there is nothing technical, ...
